Hi all,
Ive got issues with a multistack system that keeps on counting down on its display to load up the modules but once the count down finishes the relevant module doesnt start up? i have seen this on other multistacks , but generally this is because the relevant module has a fault so it skips the faulty one and starts the count down on the next one. In this case, however, there is no fault indicated on the control. So what im seeing on the control is the demand is calling for 100% , the count down counts down,some of the modules start some dont, the activated percentage will get stuck at say 50% and the count down with count down over and over again.. without activating anything and no faults appearing in the fault record?
I have tried to get a detailed manual from dunnair without much luck and sadly the tech support has been dismal.
Any help would be appreciated.
Ive got issues with a multistack system that keeps on counting down on its display to load up the modules but once the count down finishes the relevant module doesnt start up? i have seen this on other multistacks , but generally this is because the relevant module has a fault so it skips the faulty one and starts the count down on the next one. In this case, however, there is no fault indicated on the control. So what im seeing on the control is the demand is calling for 100% , the count down counts down,some of the modules start some dont, the activated percentage will get stuck at say 50% and the count down with count down over and over again.. without activating anything and no faults appearing in the fault record?
I have tried to get a detailed manual from dunnair without much luck and sadly the tech support has been dismal.
Any help would be appreciated.